Gas Line Installation in Kitsap County, WA
Gas piping is the one part of a house where an average job and a good one look identical until something goes wrong. A to Z runs gas line installation and repair throughout Kitsap, Mason, and Pierce County: new runs for ranges, dryers, fireplaces, and generators, sized for the whole load, pressure tested, permitted, and signed off by an inspector before anything gets connected.
- Third generation in the trades
- Kitsap local. No ferry, no Narrows.
- Done right, Labor backed by a full year
- Third generation in the trades
- Kitsap local. No ferry, no Narrows.
- Done right, Labor backed by a full year
- Third generation in the trades
- Kitsap local. No ferry, no Narrows.
- Done right, Labor backed by a full year
- Third generation in the trades
- Kitsap local. No ferry, no Narrows.
- Done right, Labor backed by a full year
If You Smell Gas, |Read This First|
What to Do
Get everyone out, including pets, and leave the door open behind you. From somewhere safe, outside and away from the leak, call Cascade Natural Gas on their 24-hour emergency line, 888-522-1130. If gas has ignited, do not try to put it out. Call the fire department on 911 and keep people and animals away from the area.
What Not to Do
Do not use a phone inside the building, including a mobile. Do not open or close windows. Do not flip a light switch, unplug anything, or operate any electrical device, and that includes garage door openers, doorbells, and vehicles, because any spark can ignite gas. No matches, no smoking, no vaping. Do not go back inside until you are told it is safe.
Why We Are Not the First Call
The utility is, and so is 911. They are staffed around the clock and equipped to make the situation safe, which is a different job from repairing a line. Once the gas is made safe and the property is cleared, that is the point where we come in and put it right.
New Gas Line |Installation|
Ranges and Cooktops
The most common request we get is a line to a kitchen that has never had one. Running to a range usually means getting from wherever the existing gas is over to the back of a cabinet run, which is a routing problem before it is a plumbing one.
Done properly it ends in a shut-off valve you can actually reach without pulling the range out.
Dryers
A gas dryer needs its own line, its own shut-off, and the right connector. Laundry rooms are frequently the furthest point from the meter, which is exactly why sizing matters, and it is also where an undersized run shows up as an appliance that never quite performs.
Fireplaces and Heaters
Gas fireplaces and space heaters are usually retrofitted into finished rooms. The line has to reach the appliance without a joint anywhere it cannot be inspected, which often means the run takes a longer route than the direct one.
Standby Generators
A generator asks more of the gas system than anything else in the house. It fires at high demand and it does it at the worst possible moment, when everything else is already running.
Sizing has to account for the generator plus every existing appliance drawing at once. That check happens before the line gets quoted, not after it is in the ground.
The Details That Decide |Whether It Was Done Right|
Sizing for the Whole Load
A gas line is sized for total demand, not for the appliance in front of you. Adding a range to a house that already has a furnace, a water heater, and a dryer means the shared run has to carry all of it at once. This is the single most common thing done badly on a gas job, because an undersized line still works right up until everything runs together. Traditional water heaters and tankless units draw very differently, so which one you have changes the sizing before anything else does.
Sediment Traps and Drip Legs
A sediment trap is a short vertical pocket ahead of the appliance connection that catches debris and moisture before either reaches the control valve. It costs very little to fit at installation and it is a genuine annoyance to add afterward. Inspectors look for them.
Shut-Off Valves You Can Reach
Every gas appliance needs an accessible shut-off, close enough to be useful and positioned so you do not have to move the appliance to reach it. It is a small detail that matters entirely on the day it matters.
Repair and |Pressure Testing|
How a Line Gets Tested
New and altered gas piping gets pressure tested before it is put into service. The line is isolated, brought up to test pressure, and held while a gauge confirms it is not dropping.
A line that will not hold pressure does not get connected to anything. The inspector wants to see that test as much as we do, and the job is not finished until it passes.
Repairs, Alterations, and Replacement
Older gas piping fails at joints and at corrosion points, particularly where a run passes through an exterior wall or sits in a damp crawl space. Gas line repair means finding the fault, cutting back to sound pipe, remaking the joint properly, and pressure testing the result rather than testing the repair with a spray bottle and hope.
Natural Gas| or Propane|
Which Fuel Your Property Actually Has
Cascade Natural Gas serves the Kitsap Peninsula, but a gas main does not run down every road out here. Plenty of properties in the unincorporated county have no natural gas available at all, which is why propane tanks are a common sight once you get away from the towns.
The two fuels run at different pressures and burn differently, so appliances are configured for one or the other and piping is sized accordingly. An appliance set up for one will not run correctly on the other without being changed over.
Which one you have is the first thing we establish, so tell us when you call and we will tell you what the job involves.
Permits, Inspection, |and Guarantee|
Permitted and Inspected, Every Time
What Stands Behind Gas Work
A full year covering the parts and the labor, the same as every other job we do, and the site left clean. Gas line installation across Silverdale, Port Orchard, Poulsbo, Gig Harbor, and Belfair.
One more thing worth knowing: if you are digging on your property, call 811 first. Buried gas service lines are exactly what that free service exists to mark. Anything showing on the deals page applies to gas work as well.
What Kitsap Says: "Wish We'd Found You Sooner"
See what homeowners around Kitsap have to say about working with Alex and the A to Z team.
A to Z plumbing is by far the best plumbing company out there. They are so fast to respond to your issues. They are reasonably priced and won’t charge you for things you don’t need. 100% recommend.
August 23, 2023
Alex and Michael have done outstanding work on three different plumbing issues. They respond quickly to scheduling work, show up on time, and work efficiently. They are very knowledgeable about each issue I presented. They quote pricing up front so there are no surprises. They are fair in their pricing. They are friendly and always leave a clean work area. I would highly recommend A to Z Plumbing. I know we will ALWAYS call them for any plumbing needs.
July 17, 2024
Great customer service, quality workmanship and Alex is just a great guy to work with.
August 8, 2026
My husband and I are very pleased with Alex’s work. He is very professional and trustworthy We enjoyed working with him. We will definitely use him again and be happy to refer him and his company to anyone looking for a reliable and service-oriented plumber!
September 9, 2025
Alex and Tanner were amazing! We had an interesting, and I would say challenging, situation that needed to be addressed in several ways. They were both professional and competent. Alex returned messages and calls promptly, and addressed all the hiccups we encountered quickly. He is a kind and honorable person – we are SO glad we called A to Z plumbing, and will absolutely call them for all our plumbing needs!
September 9, 2025
10/10 Would recommend. A to Z plumbing came out to repair a busted water main for me as an emergency service. Alex and his team arrived within 15 minutes of my emergency and remained cool, calm and collected. They worked together to solve the problem quickly and efficiently. They were knowledgeable and professional from start to finish. I couldn’t be happier with their service and I will be using them again for future plumbing related services. A to Z plumbing had clear pricing that was consistent with their industry. If you want something done right, don”t do it yourself. Just call A to Z plumbing and enjoy your peace of mind.
March 9, 2026
Questions Homeowners Ask Before We Come Out
What should I do if I smell gas right now?
Get everyone out including pets, leave the door open behind you, and do not touch a light switch, a phone, or anything electrical on your way. From outside and away from the property, call Cascade Natural Gas on 888-522-1130, which is answered around the clock. If gas has ignited, call 911 and do not try to put it out. Do not go back in until someone tells you it is safe.
Do I need a permit to add a gas line?
Yes. Gas piping is permitted and inspected work, and that is a good thing rather than an obstacle. The inspection is an independent check on something that will be buried in a wall for the life of the house. We pull the permit and are on site for the inspection.
Can you run a line for a standby generator?
That is a job we take, and it is worth booking the sizing conversation early. A generator draws heavily and it does so while everything else in the house is also running, so the calculation covers the whole system rather than the generator alone. Get in touch with the generator model and we can work from there.
My road has no natural gas. Can I still have gas appliances?
Often yes, through propane, which is how a great many properties in the unincorporated county run their gas appliances. The piping principles are similar and the details differ, including pressure and appliance configuration. Tell us what is on the property when you call and we will confirm what we can do.
What is a sediment trap and do I really need one?
It is a short vertical section fitted just before the appliance connection that collects debris and moisture instead of letting them reach the control valve. It is required on most appliance connections, an inspector will look for it, and it costs almost nothing at installation compared with adding one later.
Can you move a gas line for a new range position?
Yes, and it is a common part of a kitchen change. The main considerations are the route the new run can take, whether the existing pipe size supports the appliance you have chosen, and getting a reachable shut-off in the new location. It gets pressure tested and inspected the same as a new install.